La Mamba Spare Front Leg La Mamba Stainless steel hardware (including 16X

Stainless steel hardware (including 16X 8mm motor screws)

"La Mamba"

This part connects to the main PCB of your naked BMPCC4K and adapts the fragile 64-pin mezzanine connector to a more robust data port connector

Alternatively an 8in setup would be well suited for an extra powerful 8S "Crack Pigeon" using the iFlight 3110 900kV motors on 8S voltage (two 2600-3300mah 4s packs in series)

The new connector system utilizes an 80 pin interface which improves signal integrity for a clean feed to the LCD with even longer 2 meter+ cables and it allows pass through function of the original buttons circuit for familiar interface with the camera

La Mamba Spare Front Leg La Mamba Stainless steel hardware (including 16XThis is the singular folding leg that goes in front underside of La Mamba. The folding legs on La Mamba are tough, but dumping the drone onto concrete with full payload is going to break something no matter what. The 3D printed landing brackets that hold the carbon fiber legs are likely to break first and absorb impact energy, but it's likely that in a hard crash that hits the bottom side of the drone, one or more of the legs will snap (instead of the